kWeld + kCaps + kSupply + HP PSU Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case for a full kWeld system
- Ocena
- 4 / 5
- Polubienia
- 9
- Pobrania
- 79
- Wydruki
- 1
- Wyświetlenia
- 1025
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a 3D-printed case for the following components as one system:
- kWeld
- kCaps
- kSupply
- Hewlett-Packard HSTNS-PR01 power supply
The power supply locks into the base for a solid connection to the kSupply. The top of the acrylic cover for the kWeld could be glued into the front plate, but the connection is a decent friction fit for me. The top compartment can be used to store the foot pedal and power cord.
The kWeld, kCaps, and kSupply are secured with M3x12(ish) machine screws. The two halves of the base are bolted together with M4x25 machine screws. The front plate and kSupply side plate are attached using M3 self-tapping bolts.
Printing:
I printed everything with:
- 2 walls
- 2 top/bottom layers
- 0.3mm layer height
- 30% infill
- Overture PLA Pro
- Support on for the two base halves
Assembly:
- Attach the kWeld and kCaps units to the front plate
- Attach the kSupply to the side plate. Be careful with the orientation of the kSupply so that it properly interfaces with the power supply. **NB: 15mm standoffs are needed between the kSupply and the printed end plate.
- Bolt the two base halves together (which can be a little tricky if you have big hands)
- The front and then the side plate can be secured with the self-tapping bolts
- Slide the power supply in until it clicks into place