Drying Rack Rod Pin Replacemnt
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Pins for Drying Rack Rods for the Honey Can-Do rack. Make sure to print at least two, these are HALF A PIN per file!
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 108
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
These are the pins for the cross bars on the Honey Can-Do rack. I had the heads break off a few of the injection molded originals. These are a bit stronger with some design improvements. MAKE SURE TO PRINT 2 OF THE FILE. This file is only half a pin, so that the layer strength is optimal for the end result and the heads won't break off after being replaced.
Replacement is straight forward, remove the old pin and replace with your new one. I had a little trouble with some pin parts being stuck, but a little ingenuity to remove the broken parts is all that's needed. In my case, the stem of the pin was stuck inside the rod. I used a punch and a small hammer to push it further in, then inserted the replacement complete pin.