Ford Motorcraft FL-500S Oil Filter Socket - two styles
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ford Motorcraft FL-500S Oil Filter Socket - two styles - with and without hand grips
- Ocena
- 4 / 5
- Polubienia
- 39
- Pobrania
- 382
- Wydruki
- 0
- Wyświetlenia
- 1822
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This may strip out the 3/8" socket (it did with mine) due to the torque required in the small hole. The hand-grip style may be more successful.
This is an oil filter removal tool for the Motorcraft FL-500S filter which comes in two styles:
30 rib - 3" diameter
14 rib - 3" diameter
Both use a 3/8" ratchet connection.
Added a version of each which has added external protrusions for hand grip thanks to a user comment. :)
Extrusion Multiplier - set to .96 - this is important - if your extrusion multiplier is too high and you print over two perimeters, your socket attachement will squeeze in with force vs just fit. I printed this with a .96 extrusion multiplier(calibrated with the prusa cube vase mode method) in PLA and I get a proper fit. If I print this with 1.0 as my extrusion multiplier, the socket wrench barely squeezes into place. If your fit is too tight, you can heat up an extension with a torch or heat souce and instert it to open it up a touch.
Print as oriented with (3) perimeters for strength. No supports. I printed with .3mm layers for strength as well. There is a small layer to break out for the socket lock pin to push through. Just break it out. This is designed so you don't need supports for this hole, just break it through. :)
Edit - added holes for easier hanging on a peg board.