Chastity Cage Locking Pin
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement pin that uses a handcuff key to actuate.
- Ocena
- 0 / 5
- Polubienia
- 31
- Pobrania
- 677
- Wydruki
- 0
- Wyświetlenia
- 7255
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Inspired by the New Fun Chastity Cage Hinge Pin but built completely from scratch. The design is based on an unbranded cage purchased from Amazon. Use a standard handcuff key to rotate/lock it once in place.
The dimensions (diameter x length) for the individual segments of the pin are as follows:
- Cylinder+Taper: 6.28 x 18+4.5
- Dowel+Tip: 3.0 x 3.0+0.5
- Locking Tab: 3.0 x 6.0>5.25 (from centre of cylinder)
- Key Way/Peg: 3.68/2.68 x 3.75
- Key Flag: 1.0 x 3.5 (from centre of Key-Way)
The tolerances used for the handcuff key way are extremely tight to preserve as much material (and strength) around it. My Smith & Wesson key is an exact fit; it slides in with minimal resistance and lightly holds onto the pin. You may need to adjust the tolerances around your key and/or printer.
Print vertically to ensure the key way and peg print as accurately as possible. This will require a support for the locking tab, but this segment is easiest to clean up post-printing.
I've had no strength issues even with regular PLA. The key way likely won't tolerate much poking around though so I advise against trying to unlock it without the key. ;-)
The "Horizontal Scaling Factor Shrinkage Compensation" value in Cura had to be adjusted to 105% for the model to print out (according to my digital caliper) at the exact dimensions specified.