1 / 4
3D Printed Bonsai Pot 10x10x8 cm with Guiding Wires — zdjęcie 1
1 / 4

3D Printed Bonsai Pot 10x10x8 cm with Guiding Wires

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Bonsai Pot Shohin size. It has plenty drainage and guiding wires tunneling only possible with 3D Printing.

Ocena
0 / 5
Polubienia
6
Pobrania
53
Wydruki
0
Wyświetlenia
574
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

This 3D Printable Bonsai Pot takes advantage of 3D print design strategies to provide unique tunneling for guiding wires, plenty of drainage, and avoid using supports.  The drainage mimics meshing used in bonsai pot drainage holes and the guiding tunnels pass through the legs and join underneath the pot.  It's size is 10x10x8 cm, which is around the size needed for Shohin Bonsai.

Printing:

  • No supports are needed, the bottom is supported by bridges which span across the shortest possible spans.  The design has bars underneath that force the slicer to align the bridges in this way (see image below for settings and bridging/overhangs detail).
  • The models in the pictures were printed using PETG because Bonsai are outdoor plants.  PETG is notoriously difficult with bridging, so other materials should work as well.  ASA and ABS should work as well, and apparently PLA is supposed to do well with the water if the pot is used indoors.
  • The PETG models were printed using 3 walls, 3 top and bottom shells, and gyroid infill at 15%.  Somehow, concentric top and bottom and internal infill archimedean patterns made sense.  These settings result in about 150g of filament and about 6 hours print.
  • Set your Seams to Random, [at least for me] anything else ruined the legs in the model.

 

About the Pictures:

  • The tree is a “Aralia Fabian Stump” purchased at a local grocery store (Publix).  It is supposed to be a “partial shade” tree, which means that it should be outdoors with limited direct light.
  • The blue pot is printed with Flashforce Burnt Titanium PETG and the white pot is printed using Kirngroon White PETG.

Tagi