Adjustable drill press fence for 90-175mm bolt holes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Drill press fence for repeatable drilling. Uses 1/4-20 (or M6) hardware.
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 71
- Wydruki
- 0
- Wyświetlenia
- 524
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a drill press fence I whipped up for my Ryobi benchtop drill press. The bolt-down slots are adjustable from 90-175mm apart, so this should fit many other drill presses and give flexibility for adjusting the fence to different positions.
You will need to print:
- 1 fence
- 2 top flanges
- 2 bottom knob flanges
You will need to supply:
- 4x ¼"-20 nuts (or M6)
- 2x ¼"-20 x 1.5" machine bolts (or M6x45mm - length may vary depending on your drill press)
Or alternately:
- 2x ¼"-20 hex head machine bolts
- 2x ¼"-20 nuts
I sized the nut flanges for the nuts I had on hand, but you may need to resize them by a few percentage points to fit whatever your local hardware store carries.
Support is not needed, though the bottom flanges do have some internal overhang that is hidden by the nuts. If you don't use support, just chip out any loose strands with a screwdriver before assembling.
Assembly
Insert a nut into each flange. Your machine bolts should screw through the top flange, pass through the slots in the fence and the drill press, and fasten into the thumbscrews underneath.