Lian Li o11 Dynamic XL Air Flow Front Panel

There's a couple commercial options for an airflow focused panel for the o11 Dynamic XL, but they're expensive. Other panels I could find are all for the o11 evo or standard. So I made this, it's designed to fit on a CR10 or similar sized printers. I did add the full panel STL so you can hack it up into pieces as you see fit. I glued the two pieces together carefully which worked out well. You'll need a tiny bit of support on the 2 bottom tabs. The grill design matches the rest of the vents in the case.

I ended up not using the little nubbins on the top. I snipped them off, and sunk two magnets into the plastic (made indentations with a similarly sized metal rod that I heated up and melted a small hole for the magnets). Ended up working perfectly. You could also use double sided sticky tape if the nubbins don't work out for you. You could easy add holes for fans if you'd like.