Samsung Refrigerator Flexzone Drawer Parts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Why replace flimsy plastic parts when you can print stronger ones at home?
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 92
- Wydruki
- 0
- Wyświetlenia
- 860
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Share Alike
After some bits of my Samsung RF28JBEDBSR fridge broke I made some sturdier alternatives.
Which parts did I model?
- Crossbar Divider
- The part you hold to move around the two metal dividers.
- Replaced the snap mechanism with (2) M3x25mm screws.
- Divider Bracket
- Combination of 2 separate official parts.
- I modeled this but it's not tested yet.
- Use M3 screws to join front and back, and axles for the nylon wheels.
- The original model had lots of pointless geometry, but my copy is similar since before installation it was unclear exactly what dimensions were important.
Related Part Numbers
Determining these part numbers were tricky, though this partselect and partDR sites were useful.
- Tray Assembly: DA97-13814D
- Divider Bracket (Grey): DA61-10717A
- Divider Bracket (White): DA61-09409A
Printing & Assembly
I painted on a little bit of support for one part in the 3mf. If you are separating the top and bottom of the flexzone drawer to access the divider bracket, take my advice and flip it upside down and slowly pry around the outside with a screwdriver - it doesn't come apart easily.
PS
After I uploaded this I realized someone else on prusaprinters also designed a part of this bracket, if you only need the DA61-10717A portion alone.