MOLLE/PALS Zebra G-301 Pen Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple single-pen holder for a Zebra G-301 on the MOLLE/PALS system. Should also work with the Zebra F-301.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 80
- Wydruki
- 0
- Wyświetlenia
- 765
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I created this to keep a pen handy in my Jeep, which has seat covers with PALS (Pouch Attachment Ladder System) capability. I intentionally made it a thin as possible, so it will wiggle slightly when installed and occupies two bars in the system. Perfect for my intended use, but might be too loose for duty use on a vest or jacket. It does feature a drain hole, in case you get stuck out in the rain sans top.
The fitment of the pen is tight, but I've tried numerous actual pens (mfg'd from the late 90's to present) and all fit properly. The pen's clip is recessed in the body to avoid being snagged, living just the top exposed.
***Specifically made for the Zebra G-301 series pen. The F-301 ballpoint pen should also fit fine. It has not been tested with any other make/model.***
NOTE: It needs to be printed vertically, with the top on the bed surface (i.e. upside down). Printing right-side up results in the clip improperly printing (even with supports) about an inch in.
Printed on an Anker M5C-B using Creality CR-PETG. Settings I used (AnkerSlicer):
- 0.40mm nozzle
- Stock PETG Material settings
- Easy Mode
- 0.20mm layer height
- 20% infill
- Global Supports
Used ~32g of filament and took ~1hr23min to print.