Printy the Snowman! (multi-color, assembled, printed with one extruder)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A petite (5"), full-color snowman assembled from separate prints, using colors of your choice. (single extruder)
- Ocena
- 5 / 5
- Polubienia
- 25
- Pobrania
- 105
- Wydruki
- 2
- Wyświetlenia
- 501
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Winter & Christmas & New Year's
- Licencja
- Creative Commons — Attribution
I'd recommend max 0.10 layers for everything but the body, which is fine with a thicker grain. Most can be printed at light infill, say 20%.
No supports required, if you use the alternate scarf or hat (see note below).
Specifics:
Body - 0.2 is generally fine. no supports.
Arms - I recommend printing these twigs at 100% infill because they are otherwise easy to break. I've labeled them left and right, but they are interchangeable. On my printer, the side on the bed tends to be a little glossy, so I prefer to have that facing the back.
Eyes - also left/right interchangeable, but if you're fussy, left (from the snowman's POV) has one dot on the shaft and right has two (dots align to the outside)
Hat - if you really wanted to crank down the layer height anywhere, this would be the where.
If you used the alternate version with built-in supports: the support rings around the brim detach easily, but the two inner rings may take a little more work (to the point that I'll reassure you they are actually supports).
Scarf - Probably want to print this with a more parameters, since the tongue can be a little fragile. Note that there is a version with built-in supports
----Assembly Notes----
This model is not symmetrical. I designed it first, then figured out how to sectionalize it. As a result, assembly can be a tad fussy.
You'll first want to assemble the head-scarf-body. They should require a little pressure to put together (and therefore will less easily fall apart). The tongue of the scarf hangs to the snowman's left, in front of the arm. The scarf requires some force to pop it onto the base.
Everything else just gets pushed into place. The nose only fits one way: if the carrot were a bow, it would be aimed toward the snowman's left.
----Other Notes----
This could be used as an ornament, but only if glued together.
The mouth is not a separate piece, so you'll have to color it with a pen or paint. Or a paint pen.