Spool holder with PTFE channels
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remixed the original to add channels for PTFE tubes like https://www.printables.com/model/526238-2020-spool-holder
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 39
- Wydruki
- 0
- Wyświetlenia
- 425
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
Remixed https://www.printables.com/model/131300-spool-holder to add channels for PTFE tubes like https://www.printables.com/model/526238-2020-spool-holder. I liked the idea of that model but needed a good desk spool holder like the original model.
TinkerCAD: https://www.tinkercad.com/things/62pyduIiFkz-super-kup-stantia
Let me know if the clearances need to be adjusted or any other changes need to be made.
- Printed this with 15% infill, lying down on its side, with 3 walls, but YMMV.
- The holes for the PTFE tubes are 4mm in diameter, but I had to use an Xacto knife to enlarge the holes at the ends to insert the tubes, and super glue in the channels themselves to keep them flush.
- The length of the PTFE tube is designed to be 95mm but if there are clearance issues, start with 95mm pieces and cut as needed.
PS: I recently reseated the Y-axis on my Neptune 3 and the print failed near the top due to a skip as can be seen in the photo. I don't think this is an issue with the model (as evidenced by the many makes from the original).