1 / 5
Zhiyun M40w Grip and Arca Tripod Plate — zdjęcie 1
1 / 5

Zhiyun M40w Grip and Arca Tripod Plate

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A chunky grip and vertical + horizontal arca-type tripod plate for the Zhiyun M40w pocket floodlight

Ocena
0 / 5
Polubienia
5
Pobrania
27
Wydruki
0
Wyświetlenia
301
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Photo & Video
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

A chunky grip and vertical + horizontal arca-type tripod plate for the Zhiyun M40w pocket floodlight. It includes a hole for the USB port to keep charging, and plenty of room to adjust the dials without removing the grip. 

Pictured here in Prusament translucent PETG. I recommend adding some fuzzy skin on the outside using some box modifiers to make it feel nicer!

⚠ Disclaimer! Use at your own risk!

I have been using 3d printed camera accessories for years with no problems, but ultimately the safety of your gear is up to you, and I take no responsibility for any damages caused if your copy of this design breaks or does not work with your gear.

Threaded inserts

I designed this with holes to add optional ¼" 20 threaded inserts to give you even more mounting options. I used these from McMaster https://www.mcmaster.com/94459A370/ - CNC Kitchen threaded inserts are also very nice, but for this specific use case I was limited in depth, so I needed these which are slightly shorter (0.312 inches deep). 

Make sure to get a soldering iron tip to install the threaded inserts if you do not already have one - https://www.mcmaster.com/92160A131/ 

How to install

This replaces the factory leg and ¼" 20 mounting hole part. 

⚠That original part is attached with one hex screw, but it was extremely tight on mine, and may be very difficult to remove. This modification shouldn't be permanent - but be prepared for it to end up being permanent - I've heard of people breaking that screw trying to remove it. Proceed at your own risk. 

I used a screwdriver plus a big locking plier to slowly leverage it off. Once removed, the screw is easier to put back in, and this grip fits well enough that it doesn't need to be tight. 

While this may seem much bulkier than the factory ¼" 20 mounting hole + leg thing, it's actually only a few millimeters wider, so personally I don't think it increases the bulk in a way that changes how I can carry the light. 

Tagi