1 / 2
Porsche 911 991 Rear cupholder
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Rear cupholder that attaches securely in cubby between rear seats
- Ocena
- 0 / 5
- Polubienia
- 22
- Pobrania
- 86
- Wydruki
- 0
- Wyświetlenia
- 827
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (21)Powiązane
This fits in the bin between the rear seats and is secured by the nut that secures the lower seat squab to the car. To install:
- Remove rubber mat on bottom of rear bin
- Under this mat, there is a plastic door, remove it.
- Remove nut under door.
- Print cupholder
- Insert cupholder and secure with nut
- Cover nut with cap
Cup holder is at 4 degree angle so that the holder sits level with the ground. Diameter of the cupholder is 80mm, large enough for standard Hydro Flask w/rubber bottoms but not the wide models. Optional spring insert for narrower diameter cups (TPU preferred), insert ring side down.
Cupholder liner is optional and should be printed in TPU or some other flex material.
