5.25 Inch Drive Stackable Stands
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Stack your drives neatly and safely!
- Ocena
- 0 / 5
- Polubienia
- 43
- Pobrania
- 345
- Wydruki
- 0
- Wyświetlenia
- 1555
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
Print settings
- 0.2 layers should be plenty
- PLA or PETG should be more than sufficient, mine are and they're holding 10+ drives.
- 25% gyroid in-fill.
- 5 shells
- 3 walls
- Arachne or classic is fine
I made these because I have a bunch of 5.25 inch drives lying around and when I stacked them, they were unstable and I really didn't want them to topple over.
So I designed these, they're reversible so just print a pair for each drive.
They should accomodate any half height hard drive, optical or floppy.
I tested with a bunch of drives and the slots were easily able to fit them.
The slot spacing, radius, height and length were all based off of the EIA standards SFF-8501 and SFF-8551 so theoretically it should cover any 5.25 bay device that conforms.
Notes:
If you have a rather large stack, you can increase the Z scale to be a bit thicker, but you'll have to use longer screws to compensate (see my cover photo, the bottom one is 2x thicker from a previous revision of the model).
I plan to update this model at somepoint to include a base of some sort as well, just for extra rigidity, but these are already pretty solid.