Belt Clip for Dog Trainers Pouch from thetrainerspouch.com
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A self contained belt clip for treat pouches from https://thetrainerspouch.com/
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 49
- Wydruki
- 0
- Wyświetlenia
- 478
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Share Alike
I bought a silicon dog treat pouch from https://thetrainerspouch.com/ and it comes with a webbing belt to use with it. I normally wear a belt, so having a second belt was always super clumsy..
The loops in the pouch are closed, which means taking my belt off whenever I wanted to put it on / off my belt, which was SUPER clumsy.
With a belt clip, I can now just clip the pouch on or off my existing belt whenever I need to.
Printed in Prusament PETG with .3mm layer height. I printed the keeper piece with 20% gyroid infill. The belt clip must be printed on the edge (see screenshots from prusaslicer) to maintain strength under load.
I print with organic supports (not pictured) with 4 walls. This way the belt clip is all walls, so no room for infill. The belt clip is printed on it's end to ensure layer lines are maximising strength of the part.
I used two small self tapping screws to connect the two parts. There are access holes in the belt clip to allow the screwdriver to access the screws during assembly. If your self tapping screws are a little too long, just clip the sharp ends off with a good pair of wire cutters.
I have included the Fusion360 file to allow hacking.. Also in case anyone wanted to change the curve of the belt clip (I have already designed a v3 of the belt clip I am using now..)