1 / 2
PCO-1810 Soda Bottle to NATO Gas Mask Adapter
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapts full sized soda bottle threads to NATO threads for homemade gas mask filter canisters
- Ocena
- 0 / 5
- Polubienia
- 41
- Pobrania
- 414
- Wydruki
- 0
- Wyświetlenia
- 1638
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 3)Remiksy (0)Kolekcje (75)Powiązane
This component allows using water bottles / carbonated soft drink bottles to build homemade filters.
The threads on this design were created using information from this specification.
Overview
There are 2 common standards for plastic bottles - PCO-1810 and PCO-1881. The first is the older standard, and the second is the newer standard with a lower profile and less material.
Currently this design only works with PCO-1810, a PCO-1881 variant may be added later.
Building
Materials
- The printed adapter
- A plastic water bottle or soft drink bottle
- A US #18 size o-ring (metric 1.78x18.77mm) (preferred) or glue / epoxy suitable for plastics
Print Parameters
- Print Time: Approximately 1 hour 45 minutes
- Nozzle Size: 0.4mm
- Layer Height: 0.2mm
- Infill: 15%
- Supports: On build plate only (prevents unnecessary support material in between threads, aiding with support removal)
- Walls: 2
Assembly
- Print the adapter in the default orientation - with the knob on the print surface.
- Carefully remove all the support material from the bottle threads.
- Remove the bottle cap safety seal from the bottle (the plastic ring that detaches from the cap when opening), and replace it with the o-ring. Alternatively, add glue to the bottle and adapter bottle threads.

- Screw the bottle filter into the adapter until the o-ring is fully seated.
Safety Warnings
- This design will not achieve a seal if an o-ring or glue is not used. Always test the seal to ensure your selection of o-ring/glue is effective.