ScrewDriver & Plier Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
2 in 1 stand, I needed a toll holder for my pliers and screw driver so I made one I hope will fit for you to .
- Ocena
- 5 / 5
- Polubienia
- 75
- Pobrania
- 353
- Wydruki
- 2
- Wyświetlenia
- 2330
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Everything is easy to print, without supports,
There are 2 type of screwdriver holder
- with out guide
- with guide (this increase print time, in the 3mf file is with guide)
Assembly :
You will need 4x M3x6 slotted head screws for assembly the bottom and side's.(the hole for screw is 9mm including bottom part)
as for the screw driver holder I used superglue.
If you slice yourself the stl's you will need 3x Plier_Holder.
- take one left or right side and first insert the 3x plier holders as in the picture ( you may need a bit off force or lightly hammer it )
- insert 4x M3x6 screw in the bottom part till will come a bit out on the other end this is good for bether fixing the 2 side.
- place the assembled 2side and plier holder on the bottom and screw in the screw but not to tight not to damage the printed part.
- glue the screwdriver holder ( with guide or with out the guide you decide )


Print instructions
Printer Brand: Prusa
Printer: MK3S+
Rafts: No
Supports: No
Resolution : 0.2 you can try 0.3
Infill: 15%
Filament :
Devil Design PLA > Black (this I had on hand :) )
Notes:
Any material does the trick.
Standard for 0.4 nozzle I used Prusa Slicer