FT-5 OptiCooler for Titan Aero
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Upon request I have updated my previous Folgertech FT-5 Opticooler remix to fit a Titan Aero hotend with V6 block.…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 177
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
Upon request I have updated my previous Folgertech FT-5 Opticooler remix to fit a Titan Aero hotend with V6 block. Thanks again to printingotb for his original OptiCooler design!
The fan bracket simply mounts to the extruder stepper itself on the bottom two screw. Remove the screws and replace with 5mm longer screws. You may need a washer or 2. I also recommend printing the arms out of PETG or ABS with their proximity to the heater block, but they are easily removeable/replaceable.
This setup runs two 5015 radial fans wired together. Check original Opticooler for more info. I zip-tied them together to keep them in line.
NOTE: Adjust nozzles down as close the the bottom of the nozzle as possible without interfering with the print.
Print Settings
Printer:
Folger Tech FT-5
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
20%
Filament:
eSun PETGWhite
Category: 3D Printer Accessories