Eclipse Second Dawn Population Cubes Setup Device
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Device for setup Population Cubes in a board game Eclipse Second Dawn.
- Ocena
- 5 / 5
- Polubienia
- 31
- Pobrania
- 277
- Wydruki
- 1
- Wyświetlenia
- 1673
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Board Games
- Licencja
- Creative Commons — Public Domain
You will need one or two rubber bands. Population Cubes should not fall though holes unless you pressed the device on both sides.
In case you want to modify it, I attached a FreeCAD project as well
In case you want to store it in the original box I also added model with cut corner (use it with one rubber band).
Practical advice:
I printed the bottom part in vertical position so I didn't need to remove supports from the furrows, but I advise you to experiment. There were a lot of supports to remove and I needed to use a file to flatten surfaces on holes.
The square part sticking out on the bottom is for better targeting.