WG24 Slip Clutch Gauge with 20HP and 30HP values
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Spring height gauge for slip clutch provided with the 2022 WG24 stump grinder. Settings for 20HP and 30HP
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 123
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
The slip clutch provided on the PTO shaft for a WG24 stump grinder has to be set for the horsepower rating of the tractor. The slip clutch adjustment consists of tightening the springs to a given pre-load based on horsepower (HP).
This is generally done with calipers, which can be challenging due to potential interference from the PTO shaft guard. This gauge allows easy comparisons without having to deal with cumbersome calipers. This gauge has the proper heights for 20 and 30 HP.
Please note that the difference between 20 and 30 HP heights is only 0.5 mm. The printer needs to be able to produce this measure accurately. Check the printed gauge to verify actual dimensions before using. Trim any base layer “elephant's foot” before use.
PLEASE NOTE: This gauge is only intended for use with the slip clutch provided with the original 2022 version WG24 PTO shaft. The working spring dimensions for other slip clutches are probably very different. Verify dimensions for target spring height before use.
STL, Fusion 360 source and STEP files are provided.