Replacement Rubber for Toolflex 20-30 / Ersatzgummi für Toolflex 20-30
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement Rubber for Toolflex 20-30 / Ersatzgummi für Toolflex 20-30
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 75
- Wydruki
- 2
- Wyświetlenia
- 527
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a model for a replacement for the Toolflex 20-30 tool holder.
Printing
I designed this model for the Ninjaflex material (by NinjaTek), which has a shore hardness of 85A. Similar Material from a different manufacturer with the same shore hardness should work as well, but I cannot guarantee it as I have not tested it.
If your printed part is too hard or too weak, take the STEP-file and change the faces marked blue ("Offset Faces" in Fusion 360).
Print with 100% infill (or 100% walls).
-----
Dies ist ein Modell für einen Ersatzgummi für den Toolflex 20-30 Werkzeughalter.
Druck
I habe dieses Modell für das Material Ninjaflex (von NinjaTek) ausgelegt, welches eine Shore Hardness von 85A hat. Ähnliches Material eines anderen Herstellers mit gleicher Shore Hardness sollte ebenfalls funktionieren, aber das kann ich nicht garantieren, da ich es nicht getestet habe.
Sollte das gedruckte Teil zu hart oder zu weich sein, einfach im STEP-file die blau markierten Fläche versetzen (z.B. mit "Offset Faces" in Fusion 360).
Drucke mit 100% Infil (oder 100% Wände).