Moonroof latch
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement 2nd row moonroof latch
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 162
- Wydruki
- 1
- Wyświetlenia
- 576
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a replacement for the second row moonroof latch for a Traverse/Enclave/Acadia. The original factory part is installed using rivets. The plastic under the rivet head breaks and then the whole latch falls off. You can see some leftover pieces of the plastic under the rivets in the picture with the foam.
I installed this one using #6 sheet metal screws. The original rivets can be left in place and avoid the mess of drilling them out. Put the new latch in place and use the outside holes to guide a 7/64 drill bit for pilot holes. Then just install the #6 screws. Don't tighten them too much because it is only thin sheet metal.
You will want to use at least PETG. I don't think PLA will hold up to the heat on a hot summer day in a parking lot.