Gridfinity Dipping Sauce Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Gridfinity goes to the drive through! 1x2 bin adapted to fit dipping sauce and condiment packages.
- Ocena
- 0 / 5
- Polubienia
- 54
- Pobrania
- 91
- Wydruki
- 0
- Wyświetlenia
- 1304
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
Inspired by the Car Holders Contest I made a Gridfinity to Car Vent Adapter and figured I should kickoff “Gridfinity on the Go” organizers with a sauce holder!
Printing:
I used PETG, ABS/ASA would also work great. Avoid PLA if you can.
Print standing up, supports are not required.
Installation:
Takes 8 of the standard Gridfintiy 6x2mm magnets https://amzn.to/48JTSUm (affiliate link)
Need more? Put it on your Honeycomb wall with this Gridfinity to Honeycomb adapter @Chrosta created! https://www.printables.com/model/281509-gridfinity-honeycomb-wall-baseplates
Disclaimer:
Yes, I know we're technically violating the 42mm Gridfinity rule since the sauce is about 45mm wide and extends past the brim a little… But the side of the sauce container lip is really flexible so if you wanted to stack bins in front and in back of the sauce bin you could still fit a sauce container in if you needed to. Also, this was intended to be in the car, and stacking 3 wide hanging off a car vent is probably a recipe for failure and sauce all over the center console, so yeah that's my story and I'm sticking to it.