G-Fresh Spice Rack - 2 Tier 10 Container
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
G-Fresh spices don't fit normal spice racks. G-Fresh spice racks cost $60+ shipping. 880g @ 7% infil 4 perimeter 0.4mm
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 47
- Wydruki
- 1
- Wyświetlenia
- 481
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
300mm x 250mm build plate required
I bought a bunch of G-Fresh spices and herbs off Amazon because they're $4.30 each and have 2.5x the volume of the $4.80 spices containers from Coles.
I made this using simple shape volumes in PrusaSlicer and then bevelled some edges in Blender.
My print had a small gap between rounded-inside edge of the shelf and the left sidewall. I've fixed that.
I'd recommend printing on an 0.6mm or o.8mm nozzle at 0.32 - 0.4mm layer height however you can get away with 0.4mm.
MY PRINT SETTINGS:
0.4mm nozzle, 0.36mm layer height
4 perimeters
7 top layers
5 bottom layers
7% cubic infill
Custom supports for the 300mm shelf face.
Print it flat on the back.
I used E-Sun PLA+ in brown.
NOTE: Consider slowing your print down to 60-70% speed for the solid layers. I found that mine wanted to ripple and tear if I went full speed over such long faces. Corner-to-corner extrusion is around 330mm so it's a lot to ask for. In hindsight I probably should have placed some internal structure pieces in the back to break up these long lines. Might revise.