Sukhoi Design Bureau
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An easy two color print of the Sukhoi Design Bureau's old logo
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 69
- Wydruki
- 0
- Wyświetlenia
- 509
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- 2D Plates & Logos
- Licencja
- Creative Commons — Attribution — Share Alike
I was browsing the internet, looking at logos of old aircraft manufactures and wanted to see if I could recreate some of them. This finished print is approximately 104mm(4 inches) square.
Print instructions:
This can be printed easily without the MMU2 since the color changes occurs at a specific layer. I printed it in PETG, but PLA would work just fine too.
Parameters that I used were .15 layer height, 3 perimeters, 15% infill, 5 solid layers top/bottom and ironing on all top surfaces.
Just add a color change in Prusa Slicer where the print transitions from the white base to the blue details.