MMU3 top PTFE holder(for IKEA LACK enclosure v2)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is part 2 of 2 i made for my top mounted MMU 3 buffer on IKEA enclosure
- Ocena
- 4,938 / 5
- Polubienia
- 89
- Pobrania
- 389
- Wydruki
- 16
- Wyświetlenia
- 3207
- Oceny
- 16
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
This is a remix of original prusa mmu3 buffer holder.
No supports are needed to print this file.
Part 1: https://www.printables.com/model/610039-mmu3-buffer-holderfor-ikea-lack-enclosure-v2
I made this model so i could keep my spools on top of ikea lack enclosure.
It requires:
2 M3 30mm screws and 2 square nuts- i used spares from my kit
5 push connectors- i used these:
5 PTFE tubes(those you have if you bought mmu3, but i bought ones with 4mm outer and 3mm inner diameter)
Note:
Since you have your buffer above the MMU, the PTFE tube should connect the down facing collet with the MMU to reduce the angle(in the assembly instructions it is opposite since the buffer is below the MMU).