Repair for leg of Thomann "Orchestra Stand Premium" notestand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A plug that is hammered into the existing leg whose mounting holes have broken
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 163
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Share Alike
For the Thomann “Orchestra Stand Premium” (Art. 264338) notestand. One of the legs had had its mounting holes completely torn away. I designed this plug to be hammered into the tube of the (hollow) leg and provide a new hole for the mounting screw to go through.
It provides sufficient grip to stay in place with just friction, due to its length and tight fit. While I haven't yet tested it live yet, it should be able to take quite a lot of abuse.
The hole is slightly elongated to make lining it up with the position of the old holes easier. The bottom edge is also tapered to make it easier to fit in place.

An extra plug next to the repaired leg. The tear through the side of the original hole can be seen near the top.
Instructions
Print the plug with one of the lengthwise, flat sides facing down. This orientation provides the greatest strength. (The model files are already oriented the correct way.) I printed mine in PETG with 15% infill, which seems to be strong enough.
Next, unscrew the existing leg and slide the mounting screw out.
Check the edge of the leg near the broken mounting hole(s). If it's anything like mine, the tear made the metal buckle in somewhat. You need to bend this outwards slightly with a pair of pliers so it doesn't get in the way of the plug.
Slide in the tapered edge of the plug into the top of the leg and rotate it so that the the mounting holes of the leg and plug line up as best you can. Then use a soft mallet to hammer the plug down.
Try to fit the mounting screw through the hole on its own before reattaching the leg to the tripod. If it's too tight or out of alignment, use a 5mm drill to clean up the hole a bit.
Finally, reattach the leg to the tripod mechanism with the mounting screw and nut.
See also
I previously created this model for repairing the clamping mechanism for this same brand of notestand.