Carbon Filter for Anycubic Photon Mono SE
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is the DIY activated carbon filter for Anycubic Photon Mono SE.
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 63
- Wydruki
- 0
- Wyświetlenia
- 564
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
This is the DIY carbon filter for Anycubic Photon Mono SE. It should reduce some resin fumes.
The factory carbon filtration of Photon Mono SE doesn't work quite well. Two fans push fumes from build area through the activated carbon sponge to the bottom printer cavity and there large fan pushes air to the bottom of the printer. As the result, all partially cleaned air with fumes flows outside of the printed and spread all around the room.
Disclaimer:
- This filter does not completely eliminate all resin fumes, please still keep your printer in a well ventilated area.
- Involves changing manufacturer's design, so continue at your own discretion.
Materials:
- 2pcs of M3x10 screws (5.5 mm head)
Assembly:
- Unscrew build area fan
- With the M3x10 screws screw theBase to the printer
- Put Fan Pipe on the Base
- With default fan screws screw fan to the Fan Pipe by diagonal
- Fill Container with the activated carbon. You could buy activated carbon for fish tank in any Pet Store
- Close Container with theLid
- Put Container on the Fan Pipe
- With the right fan repeat the same process, but rotate the Base by 180 degrees.
Notice: the right fan wires are shorter than the left, so possibly you will need to open bottom cavity and cut cable tie or even resolder it. It is up to you.
For better result you could also seal the printer main lid joint with sealing tape or some other sealing materials.
Printer Brand: Anycubic
Printer: Photon Mono SE
Category: 3D Printer Accessories