Bins and Cases Repair and UpGrades

Would have more but kept running out of filament and documenting this is the hard part for me, so this is rushed (documentation) sorry for errors spelling or just W T F?. If I released the STL then the prints have been printed and tested on my equipment.

Higher res pictures and STEP files will be available on my website once I get around to posting.

Right now parts are for repairing and upgrading the ArtBins.

• Lockable clips / and non
• Corners and sides to support stacking
• feet for better balance when standing (hing is not on ground now)
• Various sizes to fit any damage, some need you to drill holes to fit your damage
• back plates when more is damaged
• can be used with the factory clip rod still in place
• corners and sides for factory clips, and 2 others sizes to cover the custom clips and locks
• use a bolt or zip tie too keep clips secure

in the works may finish,

• I have design for the pelican cases, but not printed yet.
• the side bins of my ArtBins will be repairable

Corners and sides have a plates glued and attached to the sides of them. This is a means to keep the layers together…. We will see..

M4 and lock nut and washers

M3 10mm 6x and heat insert and washers(these holes are only 3mm in the print, I found different inserts are different sizes so you can drill out what is good for your parts)

enjoy!