Frog Postage Stamp Dispenser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A fun desk toy for holding a postage stamp roll and dispensing postage stamps.
- Ocena
- 5 / 5
- Polubienia
- 59
- Pobrania
- 278
- Wydruki
- 5
- Wyświetlenia
- 1422
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This print is a remix of a frog sculpture I found here:
https://www.myminifactory.com/object/3d-print-frog-sculpture-3d-scan-59240
I scaled the original by 50%, and created an opening in the inside to hold a postage stamp roll, with an additional opening to dispense the stamps through the “mouth.” In addition, I made a simple cover for the bottom opening to hold the stamp roll in place.
To use the dispenser, insert a roll of stamps in the bottom, taking care to make sure the end of the roll extends into the mouth slot. Squeeze the side tabs on the bottom cover slightly, and push the cover into place.
To dispense stamps simply pull them out of the mouth slot and take as many as you need. Tear off any left over backing.
The OnShape 3D CAD file for the cover pieces is here:
Print Instructions
There are two parts to this print: The frog and bottom cover.
Print in PLA using the 3mf files provided. No infill, brim, or supports are needed for either of the pieces.