Cling Wrap Dispenser with Teeth

This remake is intended for the smaller rolls of plastic wrap that you get in a supermarket with flimsy cardboard.

A handy holder for your plastic wrap, perfect for keeping your kitchen or pantry organized, especially if the cardboard box for your rarely used plastic wrap is destroyed or if you end up ripping 3 feet of plastic wrap into a hopeless plastic rope trying to tear off enough for a plate because the teeth on the box are useless.

You will need to edit the roll holder for whatever brand of plastic wrap you use. Ours has about 3cm of cardboard on the edge. I used Tinkercad to build the one I have to securely center and "latch" the roll in place. The roll hole should move freely or with little friction, but the outside is sized to require a little effort to push into place.

The teeth are compatible with the original make of this roll holder, so if you have a larger plastic wrap roll that the original design was meant for, please make the original and use the teeth from this design.

Print Settings

Rafts:

No

Supports:

Resolution:

.2 mm layers

Infill:

Filament: PLA

Notes:

Category: Kitchen & Dining