Manfrotto Euro Profile Clamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This adapter allows quick, easy and secure holding of euro cylinders in Manfrotto Super Clamp for picking/impressioning
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 360
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This adapter is used to hold your euro profile cylinder in a Manfrotto Superclamp. The hold is very secure and works great for impressioning and picking.
The lower part replaces the plastic insert that is supplied with the clamp, simply remove the old insert by lifting it out and replace it with the new one. It has pegs that will hold it securely in the lower part of the clamp. The lower part also has a notch in the middle that allows the cam to freely rotate once the lock is opened.
The upper part goes over the upper clamp. Align the upper clamp jaws with the square pocket on the top of the and press into place until the top jaw is seated in the recessed area. Friction will hold it in place allowing you to open the clamp and remove or insert a new lock without the adapter falling off.
I printed it in PLA with 100% infill, as for layer height i printed my prototypes at .28 and the final at .08 and they they worked the same the final just looked better.