1 / 2
Holder for Seeed XIAO ESP32C3 and ESP32S3
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A lightweight holder for Seeed XIAO ESP32C3 and ESP32S3 development boards, incorporating a space for the aerial
- Ocena
- 5 / 5
- Polubienia
- 39
- Pobrania
- 198
- Wydruki
- 2
- Wyświetlenia
- 2682
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (8)Wydruki i komentarze (Wydruki: 2) (Komentarze: 2)Remiksy (0)Kolekcje (51)Powiązane
A lightweight holder for Seeed XIAO ESP32C3 and ESP32S3 development boards, incorporating a space for the external flexible PCV aerial to sit.
There are three designs:
- A compact holder which places the aerial under the board
- A holder with an extended space to place the aerial as far away as possible
- A holder with the aerial slightly closer, for if the connector is not long enough
Additionally, there are two variants of each design:
- Standard - locates on a single pip a the end of the base
- Flared - locates on the pip and has a flared end to make the holder fit more snugly
Special shout out to @FyrbyAdditive for updating their model, which I used while prototyping this model.
Printing the model
You may need to enable ironing on one or other part, as a rough top surface can make it hard to slide the parts together.