Ghost Lamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
LED Ghost Lamp with black menacing eyes and soft glow.
- Ocena
- 0 / 5
- Polubienia
- 36
- Pobrania
- 155
- Wydruki
- 0
- Wyświetlenia
- 844
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Autumn & Halloween
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This ghost lamp uses black eye inserts, printed separately, for a spooky ghost glare. The shell is 2mm thick for a sturdy lamp that will last. A lamp kit using a C7/E12 LED bulb will be needed to complete the project. Lamp kits are readily available on Amazon, Hobby Lobby, and Ace Hardware, and other stores. A photo of a lamp kit is included.
This ghost lamp was printed using Polymaker Polylite White PLA filament, which has good light transmission. Most any white filament should work fine, especially white filaments commonly used to make lithophanes, such as eSun white PLA+.
Lamp dimensions:
Height: 155mm
Width: 98mm
Print settings used are as follows:
Body Layer height: 0.2mm
Walls: 2
Top Layers: 3
Bottom Layers: 4
Body Infill: 5%
Eyes Infill: 100%
Supports: Enabled
Supports Density: 25%
Supports are required for lamp LED opening support and back of eyes support
Additional parts needed:
A C7/E12 LED lamp kit - https://www.amazon.com/Kiraralite-Accessory-Candelabra-Equivalent-Incandescent/dp/B0BPS7G5YD?th=1
Note that some kits include an incandescent bulb and many craft stores and even hardware stores stock them.
*** Use ONLY LED bulbs with this lamp. ***