Industrial Base Tower QUBE 500
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Industrial Base set up for the QUBE 500. Can be printed in 2 colors.
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 52
- Wydruki
- 0
- Wyświetlenia
- 440
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props & Terrains
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Added 3mf for print setup. I used superglue on beams, and walkway.
If you like these models, it'd mean so much to me if you buy me a coffee.
Parts list
part-1: door frame
part-2: need 2, door walkway beams
part-3: above door
part-4: panel right of door
part-5: panel left of door
part-6: top layer (door side) center
Part-7: top layer right of door
part-8: top layer left of door
part -9: door walkway long
part-10: door walkway corner
part-11: walkway side
part-12: door
part-13: center bottom (below door)
part-14: bottom right
part -15 bottom left
part-16 bottom side
part-17: side 1 (wall)
part-18: side 2 (wall)
part-19: side beams (need 2)
part-20: front beams (need 3)
part-21: corner grate (no Elephant foot compensation) 1mm-2mm Z only
part-22: grate (need 6) (no Elephant foot compensation) 1mm-2mm Z only
part-23: front long handrail (no Elephant foot compensation)
part-24: front short handrail (no Elephant foot compensation)
part-25: side handrail (no Elephant foot compensation)
part-26: end handrails (need 2) (no Elephant foot compensation)
Parts-27-32 (no Elephant foot compensation) print face down
part-33: Door size walkway Then add 2, part-26 to the ends.
part-34: Door size rail (no Elephant foot compensation)