Traffic Cone (Pylon) & Barrier Set

Traffic cones are too big to fit on your desk so why not make some model cones for decoration or play? These 52 mm tall models stack together like real cones.

There are three models ready to print. First, the snap together multi-colour model makes gluing the parts easier. Next a print-in-place multi-colour model is easy to make if you can manually switch colours like with most Prusa printers. Finally a simple model is provided for easy one-step printing.

Dopravní kužel

ロードコーン

General Print Settings

• PLA filament, one or two colours
• 0.4 mm nozzle
• 0.2 mm layers
• infill 15%

Multi-Colour Traffic Cone (from Parts)

Gather your materials:

1. Main colour PLA filament. Orange or dark blue work well. 
2. Accent colour PLA. Matte white works well.
3. Cyanoacrylate adhesive
4. A small file
5. A sharp blade to remove flashing

Print and Assemble:

1. Print without supports or brims
2. Print the parts labelled “orange” in the main colour.
3. Print the parts labelled “white” in the accent colour.
4. Check to make sure the parts fit well. Some light filing or trimming will make edges align cleanly.
5. Use adhesive to permanently assemble the five parts.

Multi-Colour Traffic Cone (Print-in-Place)

Gather your materials:

1. Main colour PLA filament. Orange or dark blue work well. 
2. Accent colour PLA. Matte white works well.
3. A small file
4. A sharp blade to remove flashing

Print and Assemble:

1. Print without supports or brims
2. Make sure you have both colours ready. 
3. The multi-colour file contains colour changes for Prusaslicer.
4. If you need to recreate the colour changes use the following divisions:
   1. 24.0 mm change to white
   2. 29.0 mm change to orange
   3. 34.0 mm change to white
   4. 39.0 mm change to orange
5. Some light filing or trimming will clean up the first layer nicely.

Single-Colour Traffic Cone 

1. Print without supports or brims
2. Some light filing or trimming will clean up the first layer nicely.