1 / 7
Actually working Y Splitter for Bambulab printers
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A working Y splitter for Bambulab printers. Easily printed, compatible with current PTFE tubes.
- Ocena
- 5 / 5
- Polubienia
- 40
- Pobrania
- 248
- Wydruki
- 6
- Wyświetlenia
- 1229
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 6) (Komentarze: 10)Remiksy (1)Kolekcje (53)Powiązane
An actually working Y splitter for Bambulab printers to be used to allow AMS and manual feeding without PTFE tubes switching
NOTICE: Must follow instructions:
- This should be printed in 0.1 layer height !!
- Connect as follows: A - AMS | M - Manual feed | P - to printer
- Print with flat surface on print bed
- Push the PTFE all the way in - it should be fitted into print
- Print - run a filament through each entry making sure no leftovers from the printer.
- Make sure the PTFE connecting the splitter to the printer is cut straight
After trying many Y splitters which failed, I reached the conclusion the Y splitter (actually joiner) should be designed differently:
- AMS feed should be flawless and therefore prioritized (nobody cares about manual success rate)
- there shouldn't be a “joined tube” print - either a round feeder, or printer friendly “chamber”
- the design should take 3d printers characteristics in mind - print direction should be aligned with flow direction, no changes in printed tubes
- connect easily with existing PTFE tubes
taking all this in mind I designed an externally flat print, with “join chamber” instead of joining tubes. this one is compatible with standard PTFE (4mm) and 10 mm fitting connectors