Quest 3 Touch Controller Wall Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A wall mount to neatly hold the Meta/Oculus Quest 3 touch controllers
- Ocena
- 4,935 / 5
- Polubienia
- 236
- Pobrania
- 1668
- Wydruki
- 33
- Wyświetlenia
- 6278
- Oceny
- 31
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Virtual Reality
- Licencja
- Creative Commons — Attribution — Noncommercial
I wanted a wall mount that would hold the Quest 3's controllers without risk of them slipping out or getting damaged.
Settings used:
- Layer Height = 0.20mm
- Walls = 3
- Infill = 20%
- Supports = On
- Brim = On
Small amount of support required for the ends of the arms, may get away without support, but I would recommend them being enabled (example pictured)
I created this by approximately profiling around the Quest pro controllers to have a bespoke fit, so this will NOT fit the Quest 1 or 2 controllers (due to the rings and slightly different design).
There are 3 versions, one that has a screw mount (recommended), a riskier double sided tape mount (untested!) if you can't drill into walls etc. and one compatible with the Skadis T-Clip system.
Changes 16/10/23:
- Added Skadis T-Clip mounting method
Headset mount: https://www.printables.com/model/615721-quest-vr-headset-wall-mount