easy tool for nyloc nut mod for prusa for mk2,5s mk3s, mk3s+
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
required 3x M4x40 mm screws and 4x M4 nuts and 2x M5x20mm screws and 2x M5 nuts. Printed from PETG. Dial indicator you…
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 59
- Wydruki
- 0
- Wyświetlenia
- 1406
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
required 3x M4x40 mm screws and 4x M4 nuts and 2x M5x20mm screws and 2x M5 nuts. Printed from PETG. Dial indicator you can buy on Ali for less than 10 eur.
Firstly it is needed to set X axis to horizontal position. It is done with top Z holders, where there are M5 screws to set up end of the movement, when you reach top of the Z height. I measure distance of x axis steel rod from both Y axis (bed) rods. Move bed to the most front position and you can measure. Adjust top screws so distance of the x axis steel rod is equal from both Y axis rods.
Then mount tool with indicator so you can still slide it on rods and you can adjust all 9 (for mk 2,5s just 4 screws) screws of the bed to one distance . That way your bed will be perfectly flat. I was able to set it in range 0,02 mm. I think it is enough.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
No
Supports:
No
200
Infill:
20
Filament:
PM PETG any
Category: 3D Printer Accessories