Remix: Milwaukee M18 QuickCharge 3.0 USB Adapter by Zoggee

Summary

The original model of this was very well designed, but incomplete. I just made the finishing touches.

Needed materials:
-https://www.amazon.com/gp/product/B0776PY5JK/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

-https://www.amazon.com/gp/product/B087RHWTJW/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1
or these: https://www.amazon.com/dp/B07KWVL77T/ref=sspa_dk_detail_4?psc=1&pd_rd_i=B07KWVL77T&pd_rd_w=ckFgG&content-id=amzn1.sym.f734d1a2-0bf9-4a26-ad34-2e1b969a5a75&pf_rd_p=f734d1a2-0bf9-4a26-ad34-2e1b969a5a75&pf_rd_r=GJ0EGN6VFD70G9FP1NB1&pd_rd_wg=k2d0y&pd_rd_r=ffae560a-83f6-4ef6-b2bb-d82e42f1366b&s=industrial&sp_csd=d2lkZ2V0TmFtZT1zcF9kZXRhaWw

-(4) M3x20 screws
-small gauge wire
-some way to splice wires

You'll also need to do a bit of soldering.

First, you'll need to remove the insulation from the red piggyback connectors. Next, you'll solder a short length of wire to the piggyback, try not to get the solder on the outside of the barrel (pictured above). Then, straighten the piggyback connector so the spade is straight. Now you can fish the wire through the bottom to the middle section. Push the connector into the lower, it will be tight. Make sure only the flat part is sticking out. Do this for the + and - terminals.

Solder a short section of wire to the USB modules. Place them into the middle section, they should stay in place once the lid is on. Now, connect all your wires however you'd like. Connect all the positives together and all the negatives together. I like using Wago lever locks that are glued to the case(as pictured). Lastly, install the lid. All three sections will be held together by the screws.