[Fusion360] Scalable parametric Hinge
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple Scalable and parametric Hinge designed in Fusion 360. probably wont work in other programs
- Ocena
- 5 / 5
- Polubienia
- 35
- Pobrania
- 674
- Wydruki
- 1
- Wyświetlenia
- 4627
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Share Alike
This is a Scalable Hinge designed in Fusion360, i'm new to 3D Modeling and printing, i needed a hinge for one of my designs and lost a lot of time redrawing the Hinge to fit my needs. so i designed this simple scalable hinge, it took me more than 20 hours to get to this version.
Parameters:
- Length: length of the leafs
- Width: width of the leafs
- Height: (Height of the complete hinge (the pin diameter and barrel scales with height)
- Tol: Tolerance between basic movable parts
- TolPin: Tolerance between pin and barrel
- TolBarrel: Tolerance between barrel and Joint
- Angle: Angle of the right leaf (-90 to + 90)
- MaxBridge: set to desired bridge length. this must be lower than the maximum bridge you can print, (if you print at an angle, set this lower)
please leave a like or a comment, this is my first design, im very proud of it.
Smallest settings ive tried on BambuLab P1S With BambuLab PLA
height: 2.5mm (Works Flawlessly) Havent tried smaller
tol: 0.4 (0.3 is a little too tight)
tolpin 0.4
TolBarrel: 0.2 feels good enough.
max Bridge ive always kept as low as possible. long bridges are a weak point
V2.0 Changes
- fixed some bugs
- maximum quantity of hinges is now 250
- removed logo completely (created more problems than anything else)
- added radius to pin adhesion to the joint for extra strength