1 / 2
SKR V1.4 Turbo Board Mount and Stepper cooler for Sidewinder X1 — zdjęcie 1
1 / 2

SKR V1.4 Turbo Board Mount and Stepper cooler for Sidewinder X1

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a remix of the Turbo board mount with the "Stepperdriver Coolingduct for Sidewinder X1"…

Ocena
0 / 5
Polubienia
6
Pobrania
70
Wydruki
0
Wyświetlenia
565
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

This is a remix of the Turbo board mount with the "Stepperdriver Coolingduct for Sidewinder X1" (https://www.thingiverse.com/thing:4001447) also mixed in.

The bracket clips onto the board mount and the cooling duct is screwed to the bracket. You may need a step-down-converter when using a 12V fan (5015), which can be screwed to the bracket aswell.

I installed this bracket without any problems and due to the two mounting points for the setpdown-converters it is possible to use 12V fans for the case cover and the stepperdrivers and tune the voltages individually to turn down noise but being able to keep the airflow high at the same time. For my liking I use a winsun fan for the stepperdrivers but found it to be a little loud so I tuned it to around 8.5 V while being able to keep the case fan at 12 V.

Print Settings

Printer:

Artillery Sidewinder X1

Rafts:

No

Supports:

Yes

Resolution:

0.2

Infill:

20%

Filament: ERYONE trans red PETG PETG red

Notes:

print with PETG/ABS/PC/... maybe up the infill or use sufficient shells. I used 3 for my prints (lets see how they hold up). Supports should be used for the mount bracket, the stepperdriver cooling duct i printed without supports (be sure that your bridging is good enough on PETG)

Category: 3D Printer Accessories

Tagi