Ender 3 S1 (and Plus) USB-C Stabilizer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Loose USB-C connection on your Ender 3 S1 or S1 Plus? This insert will help to tighten that loose sloppy hole.
- Ocena
- 5 / 5
- Polubienia
- 31
- Pobrania
- 214
- Wydruki
- 2
- Wyświetlenia
- 1528
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I have found that the USB-C connector on my Ender 3 S1 is very loose, no matter what cable I put into it. This insert slides right into the cutout area, where the cable and SD cards are plugged in.
While it does not remove ALL extra play in the connection (and honestly, you want some space for the cable), it removes more than enough to keep the cable from losing any contact with the machine.
What makes it better is that it does not remove or hinder the functionality of either!
Printing this with a brim may help out some, due to the sharp corners.
I hope that this will help you, as much as it is helping me!
Layer lines: 0.3mm
Supports: n/a
Ironing: on
If this helps you, please give a like and share comments and suggestions, from your experiences. I’m always open to constructive feedback!