1 / 4
Filament Cutter for Sherpa and Sherpa-patterned Extruders — zdjęcie 1
1 / 4

Filament Cutter for Sherpa and Sherpa-patterned Extruders

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a filament cutter that sandwiches between the Sherpa extruder and whatever hotend you're using

Ocena
4,25 / 5
Polubienia
152
Pobrania
704
Wydruki
3
Wyświetlenia
7333
Oceny
4

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v2.0

A remix of JB3D's design that eliminates 3 parts, exchanges a single 5mm('ish, you can use anything from a pen to a 7mm diameter) spring for the two springs of the previous design, and uses a standard exacto #11 blade instead of a 9.2mm wide box cutter blade.  

I use this with a tradrack MMU to avoid tip shaping.  You need to design a block that fits to the left side (as you're looking at it) gantry or frame somewhere for the toolhead to push against.  

Tagi