Bucket dirt guard
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Dirt guard keeps the water in a bucket cleaner by allowing the dirt to fall on the bottom and not raise up again.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 54
- Wydruki
- 0
- Wyświetlenia
- 595
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The dirt guard's outer diameter is 20,5cm. The riser clips lift the guard 1cm above the bottom of a bucket. The design is optimized for Orthex 10l bucket, but you can obviously scale the design bigger or smaller depending on your bucket size.
Important to print with 100% infill, otherwise the dirt guard will float.
Print instructions
Print 1 x dirt_guard and 4 x dirt_guard_clip2.
Orientation: Clips best printed “sideways”
Supports: Not needed
Layer height: 0,2mm
Material: PLA, PETG
Infill: 100% (IMPORTANT, otherwise the dirt guart will float)
Raft: not needed
Assembly instructions
Place the four clips on the second outmost cicle of the dirt guard. The higher part should be on the inner side of the circle for best fit. A small drop of superglue can be used to ensure the clips stay in place, but it is not mandatory.