ATO Automotive Fuse Holder Spade Terminal
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
With two female spade terminal connectors, and an ATO fuse (green one in the picture!) you can have a fuse holder!
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 103
- Wydruki
- 0
- Wyświetlenia
- 916
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
With two female spade terminal connectors, and an ATO fuse (green one in the picture!) you can have a fuse holder! In the picture, you'll see two spade terminals, which can be inserted in one end (after crimping your wires) and the other end will accept the fuse. It isn't a tight fit for the fuse to allow variance in approach angle.
Use caution with this, while I think it is fine and safe and wonderful, it might not be. 3D Printers use low temperature plastics with varying conductivity. Your fuse may not blow, or it may cause this to melt or other problems.
That said, I'm using it for things.
No obligation at all, but if you like this model, you can Buy Me a Coffee.