Airbrush Cleaner using 500g Vegemite Jar
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an Airbrush Cleaner that fits a 500g Vegemite Jar. Fits Iwata HP-CS and Harder & Steenbeck Infinity
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 57
- Wydruki
- 0
- Wyświetlenia
- 457
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is an Airbrush cleaner designed to fit on a 500g Vegemite Jar. All parts can be printed without supports. You can put a small wad of cottonwool in the breather on the top and put the cap on.
Fits Iwata HP-CS and Harder Steenbeck Evolution. Should fit most other top cup airbrushes. When filled with cleaner it is very sturdy.
Obviously if you print it in material which is softened or dissolved by your cleaning fluids then it will melt…. I printed in PLA and use it with water-based acrylics and it seems fine.
Parts do not require support and should be printed as follows:
- Top collar - upside down
- Main cleaner - right way up
- Filter-cap - upside down
Assembly should be self explanatory
- There are gaps in the threads to enable the centre to slot in.
- Do not overtighten - you will eventually be able to split the rim on the top if you do
- Do not press the filter cap in too hard - it is chamfered to fit with PLA so should be a good fit if your printer is set up OK
- Assemble the top parts and mount on the jar before you insert the filter cap as it sits over the edge of the top collar (unless you turn it around)
*Jar and Airbrush not included :-)
** If you don't like Vegemite - befriend someone who does!