1 / 2
Parametric Breakout Board for Arduino Nano — zdjęcie 1
1 / 2

Parametric Breakout Board for Arduino Nano

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Tight fit of Parametric Breakout Board Sockets (ESP8266 NodeMCU, Arduino Nano, etc) for Arduino Nano.

Ocena
0 / 5
Polubienia
7
Pobrania
75
Wydruki
0
Wyświetlenia
456
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Share Alike

This is a remix of – https://www.printables.com/model/118444-parametric-breakout-board-sockets-esp8266-nodemcu-

I use the board as holder for Arduino.

I printed this with PETG at 0.15 layer height, 15% infill, 3 perimeters, 3 top & bottom layers.

I calibrated the extrusion width for the spool with the following guide – https://guides.bear-lab.com/Guide/Extrusion+multiplier+and+filament+diameter/8

The original design printed on my printer is a little loose, and a board can be shaken out of the holder. I adjusted the settings (pinwidth parameter) by reducing the size of pin holders by 0.15mm to 0.95mm from the original 1.1mm.

 

 

Tagi