2x Vernier Calliper holder for #Gridfinity with 4x batteries
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A holder for 2x "generic brand" Vernier callipers
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 38
- Wydruki
- 0
- Wyświetlenia
- 327
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
I have two of these cheap, metal, unbranded Vernier callipers, and wanted to create a Gridfinity holder for both, plus 4 batteries.
Instead of wasting a print on someone else's design that doesn't fit this model, I decided to waste about 5 prints on designing my own and getting it wrong, but eventually right.
Interestingly, my 2 callipers (exactly the same design) had tiny differences in the length of the jaw, so obviously I used one calliper to measure the other, then one of them didn't fit on the first go…
Anyway hope this is useful for someone. It's a needlessly complicated design, which probably causes more problems than it solves, but that's how my brain works.
ALSO - DISCLAIMER - the batteries were supposed to be friction-fit. I tried a few times to get the tolerances right but once I managed to get the ruddy callipers in, I took a sigh of relief and gave up on the battery holes. They hold batteries, but not exactly with much ingenuity.