Original Prusa Enclosure Filament Guide Left with Thermometer

Print instructions

• print settings: 0.20mm QUALITY
• filament: PETG
• 15-20% grid infill

What is needed:

• 2.5mm Allen key
• 5x M3n nut
• 2x M3x12 screw
• 3x M3x8 screw
• 1x zip tie
• PTFE-Tube 4x650mm
• Filament Guide A
• THERMOMETER BRACKET FS Guide
• TOP_PLUG_CENTER with PTFE Tube Holder
• Something to push the nylon rivet out

Install Instructions:

• Unscrew the old Thermometer bracket and take out the 2 M3n Nuts (we will need them later)

• Now Take your Printed parts, we will start with Filament Guide A and insert all the 5 M3n nuts.

• Now push the Thermometer out of its old housing and push it inside of the new one.

• Take the three M3x8 Screws and screw them into the the holes just like on the picture above (do not tighten them all the way yet!)
• Insert the PTFE Tube all the way in until you see the end on the other side

• Now align the new bracket with the holes in the Enclosure and use the two M3x12 Screws to fix the bracket in place

• Fixate the new PTFE Tube with a zip tie to the first hole 

• Now use your choosen Tool the remove the nylon rivtes (do not destroy them you will need them right afterwards again) Just push them upwards.

• Replace the old Top Hole Plug with the new one. Use the old rivets to fix it in place again

• Now Just put your PTFE Tube inside and your done. During Printing now the other tube wont get in your way